SGMII SFP

Description

The SFP transceiver is high performance, cost effective modules. It is designed for 100BASE-LX applications of 10km with SMF. The transceiver consists of two sections: The standard SFP part and the PHY part built with SGMII interface. The optical output can be disabled by a TTL logic high-level input of Tx Disable, and the system also can disable the module via I2C. Tx Fault is provided to indicate that degradation of the laser. Loss of signal (LOS) output is provided to indicate the loss of an input optical signal of receiver or the link status with partner. The system can also get the LOS(or Link)/Disable/Fault information via I2C register access. The standard serial ID information Compatible with SFP MSA describes the transceiver’s capabilities, standard interfaces, manufacturer and other information. The host equipment can access this information via the 2-wire serial CMOS EEPROM protocol. For further information, please refer to SFP Multi-Source Agreement (MSA).

Features

- Build-in PHY supporting SGMII Interface

- Build-in high performance MCU supporting easier configuration

- 100BASE-LX operation

- 1310nm FP laser and PIN photo-detector

- 10km transmission with SMF

- Standard serial ID information Compatible with SFP MSA

- SFP MSA package with duplex LC connector

- With Spring-Latch for high density application

- Very low EMI and excellent ESD protection

- +3.3V single power supply

- Operating case temperature: 0 to +70°C

Applications

- Switch to switch interface

- Switched backplane applications

- Router/Server interface

- Other optical transmission systems

Standards

- Compatible with SFP MSA

- Compatible with IEEE 802.3ah-2004

Ordering information